Monday, August 4, 2014

Centuri Powr-Pad Launcher and Controller, Part 2, Internal Wiring




The metallic stickers are applied first.
The blue plastic housing pieces were washed off first to remove any mold release.
The edges were pressed in place with a Q-tip. I didn't want to take any chance of the ink rubbing off.



A knot is tied in the wire for strain relief. The length of the wire end to the knot is the length of the inside housing wall.


The brass contact pieces are screwed in place but not fully tightened.
The gap between the two pieces in the lower half is intentional. The safety key bridges the gap allows the current to go through the continuity light.

No comments:

Post a Comment