Friday, August 15, 2014

Centuri Screaming Eagle Build, Part 8, Fin Stickers



The four oval stickers go on the right side of each fin.
Before removing the backing, set the sticker on the fin to visualize the centering.
To be sure the oval is centered, I traced the fin outline on some card stock and cut it out.
A rectangle was cut out of the center the same height and width of the sticker.
The card stock piece was taped to the fin.
Place the sticker using the tip of your knife, not with your fingers.
I didn't want any finger oil to diminish the old adhesive.



Here's one sticker in place.
The inset picture is viewed from the rear. It's hard to see in the picture, but the baseline of the Centuri logo is parallel to the root edge of the fin.

No comments:

Post a Comment