Thursday, August 20, 2015

Estes Lynx, Kit #7233, Build Part 13, Intake Tube Gluing



Dry fit the intakes before using any glue.
Hold in place and trace around the ends for easier placement when the glue is used.

Apply glue to the inside edges of the intakes. Keep glue off the outside edges.



With the engine mount out you can hold down the intake ends.

Here's the underside of the model with the intakes in place.

Apply fillets where you can. Remove excess glue with a Q-tip. You'll never get a fingertip in the tight areas by the wings.

No comments:

Post a Comment